aguda
GF Ouro
- Entrou
- Ago 28, 2007
- Mensagens
- 19,102
- Gostos Recebidos
- 2
Software for AZAmerica S810 & S800
S800 & S810 Loader
Use null modem cable (pinout,2-3,3-2,5-5).
Select Comport speed= 115200 parity=even
Chave power desligada
Browse ... select file.
Next .... Ligar chave power.
Na tela diz reset target ..... Done. ( Se nao test COM , cabo, receiver).
Progress bar .......100%
Next ....to burn flash.
Progress bar ......100%
S810 Bad upgrade recovery - display "ON"
1) Download loader by recovery S810 : S810 RS232 Recovery Software Loader
2) Download S810 factory bin: S810_factory.abs
3) Swich on by rs 232 cable null with the receiver turn "OFF" from the back switch
4) Open software loader , choose factory.bin and connect
5) Turn on the equipment and wait to the end of charge.
6) Accept and wait then the end of flash recording process
7) Load the last firmware of the forum
S800 Bad upgrade recovery - display "ASH"
1) Download loader by recovery S800 : S800 RS232 Recovery Software Loader
2) Download S800 factory bin: S800_factory.abs
3) Swich on by rs 232 cable null with the receiver turn "OFF" from the back switch
4) Open software loader , choose factory.bin and connect
5) Turn on the equipment and wait to the end of charge.
6) Accept and wait then the end of flash recording process
7) Load the last firmware of the forum
duvidas AQUI :right:
TRADUTOR :right:
S800 & S810 Loader
Use null modem cable (pinout,2-3,3-2,5-5).
Select Comport speed= 115200 parity=even
Chave power desligada
Browse ... select file.
Next .... Ligar chave power.
Na tela diz reset target ..... Done. ( Se nao test COM , cabo, receiver).
Progress bar .......100%
Next ....to burn flash.
Progress bar ......100%
S810 Bad upgrade recovery - display "ON"
1) Download loader by recovery S810 : S810 RS232 Recovery Software Loader
2) Download S810 factory bin: S810_factory.abs
3) Swich on by rs 232 cable null with the receiver turn "OFF" from the back switch
4) Open software loader , choose factory.bin and connect
5) Turn on the equipment and wait to the end of charge.
6) Accept and wait then the end of flash recording process
7) Load the last firmware of the forum
S800 Bad upgrade recovery - display "ASH"
1) Download loader by recovery S800 : S800 RS232 Recovery Software Loader
2) Download S800 factory bin: S800_factory.abs
3) Swich on by rs 232 cable null with the receiver turn "OFF" from the back switch
4) Open software loader , choose factory.bin and connect
5) Turn on the equipment and wait to the end of charge.
6) Accept and wait then the end of flash recording process
7) Load the last firmware of the forum
duvidas AQUI :right:
TRADUTOR :right:
Última edição: